What ought to I pay out attention to when cleaning the dew stage sensor in the glove box

acrylic glovebox cleansing (only for washable probes)

one) Purpose: If the water probe is not cleaned for a extended time, some dirt will adhere to the surface, influencing the detection.

cheap glovebox ) Actions:

① Close the cycle and analyzer



② Set the functioning force to +five to + 8mbar

③Remove the drinking water probe and speedily blind the air outlet with a blind plate

④Unscrew the metallic protective protect on the entrance of the probe, clean it with deionized h2o, and then dry it with dust-free of charge paper, then moisten the probe with dust-free paper dripped with cleansing fluid, and use evenly

⑤ Set it back in place, open up the cycle, switch on the analyzer right after 1 hour, and return to standard degree soon after half an hour.

note:

Soon after the water probe is cleaned, the glove box strain is set to the first worth, and the cycle is turned on but the analyzer is turned on yet again after 1 hour, since after the h2o probe is cleaned, the probe area is cleaned with deionized h2o or sixty five% concentrated phosphoric acid wetting contains drinking water Of course, if the analyzer is turned on prematurely, the drinking water benefit will always be detected and exhibited to exceed the normal, so it is needed to flow into in the tank for a although and wait around for the h2o vapor to dissipate prior to turning it on once more.